Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
13
OPERATION
Device to be operated in a perfect state only. Inspect the device visually every time it is to be
used. Check in particular the safety equipment, controls and screwed connection for damage and if
tightened properly. Replace any damaged parts before operating the device.
13.1 Operation instructions
Disengage clutch lever before starting the engine
Always guide the unit with both hands
First engage, then accelerate
Do not overload the machine capacity
Always make certain that the weight is evenly balanced
Change the gears only when the machine stands still!
Go up slopes in one turn without stopping
Do not tipping on soft ground
Before start operating, check the dump box to make sure it is locked
Attention: While tipping the centre of gravity will change
13.2 Functions of components
1 Engine switch: The engine switch must be in the ON position for the engine to run.
Turning the engine switch to the OFF position stops the engine.
2 Throttle control: Controls engine speed. Put the throttle control on low speed (L) or high
speed(H)
3 Right steering lever: Operate the lever to turn right
4 Clutch control lever: Squeeze the lever, clutch engaged. Release the lever, clutch disengaged
5 Left steering lever: Operate the lever to turn left
7 Gear selection lever: Controls forward (3x) or reverse (1x) movements of the machine.
8 Tipping handle: Controls the tipping of the dump box
13.3 Start up
13.3.1 Fill in engine oil
ATTENTION! For transport motor oil has been drained. Fill up with 4-stroke
quality motor oil before first operation! Failure to do so will result in
permanent motor damage and void guarantee!
A too low oil level will cause damage to the engine and shorten the service
life of the machine. Therefore, check the motor oil level before every start
and if necessary fill up with oil.
ZIPPER MASCHINEN GmbH
ZI-MD500HST
www.Zipper-Maschinen.at
NOTICE
WARNING
NOTICE
OPERATION
32
Publicidad
Tabla de contenido
