Operation; Start Engine; Idle Speed; Stop The Engine - Zipper Maschinen ZI-MD500HST Instrucciones De Servicio Complementarias

13.4 Operation

13.4.1 Start Engine

Start the engine, if you have your wheeled dumper mounted correctly:
 Set the gear selection lever (7) to the neutral position.
 Move the choke lever on the machine to the full choke position.
 Turn engine switch to "ON".
 Pull the starter rope several times so that the carburettor is filled with gasoline.
 Pull the starter handle, pull-out until resistance is felt. Let the rope rewind slowly across and then
move expeditiously.
 Run the pull-starter handle slowly to the rope guide back as soon as the engine starts.
 Set the choke lever after a few seconds of engine run position ˝OPEN˝
To start the engine is warm the choke lever is not to be operated.
 When the engine is warmed up, place the gear lever (7) (forward / reverse) in the desired position.
If the desired gear cannot load, press the clutch lever short and repeat the process. After inserting
the gear lever Push the clutch lever and the mini transporter begins to drive. Drag to adjust the
throttle lever to the speed accordingly.
 With the steering arm on the handles and can be easily controlled. To drive in the desired direction
each use the right or left steering lever.

13.4.2 Idle speed

Throttle lever to the "SLOW" (SLOWLY) take to protect the motor if no work is done.
Downshifting the engine to idle prolongs the life of engine reduces fuel consumption and the noise
level of the machine.

13.4.3 Stop the engine

To stop the engine, release the clutch lever and turn the switch on the motor to the "OFF" position.
Under normal conditions, proceed as follows.
a. Move the throttle lever to the SLOW position.
b. Allow engine to idle for 1-2 minutes.
c. Turn engine switch to OFF "OFF".
d. Turn the fuel valve lever to OFF.
ATTENTION: Not move the choke lever to stop the engine to CHOKE. Risk of reignition or damage to
the engine!
NOTES
 The steering characteristics change proportional to the speed driven and the laden weight. The
lightly loaded machine can be steered with lighter lever operation. With higher loading of the
steering lever to control with higher pressure.
 The highest loadings of the machine is according to the floor on which the machine is used to
adjust.
 It is therefore recommended to drive on difficult tracks in a low gear and with caution. In such
situations, the machine to be driven over the entire range in a low gear.
 Avoid sharp turns and frequent changes of direction when driving on the road, especially on rough,
tough terrain, which has many sharp, uneven areas, causing high friction.
 Although the machine has rubber tracks, please remember, to be careful when working under
adverse weather conditions (ice, rain and snow) or on soils where the machine could be unstable.
 When the clutch lever is released, the machine is automatically braked and stops.
 If the machine is stopped on steep slopes, one of the tracks must be secured with a wedge.
ZIPPER MASCHINEN GmbH
ZI-MD500HST
www.Zipper-Maschinen.at
OPERATION
34