Installing The Infant Carrier Without The Base; Using Vehicle Lap And Shoulder Belt - CYBEX ATON Manual Del Propietário

Installing the Infant Carrier without the Base

Using Vehicle Lap and Shoulder Belt

1. Position Infant Carrier on a forward facing vehicle
seat so child is facing the rear of vehicle.
2. Route only the vehicle lap belt under
both Belt Guides. Buckle the belt.
3. Lift shoulder belt over handle and
around Carrier. Slide shoulder belt into
the BLUE Shoulder Belt Guide (a).
4. LOCK your vehicle lap shoulder belt. Refer
to your vehicle Owner's Manual
your vehicle lap and shoulder belt locks.
In many vehicles, you can switch the shoulder belt
retractor into locking mode by pulling the shoulder
belt out all the way. In some vehicles the buckle
locks. Check the vehicle Owner's Manual
how your system locks.
To check if the vehicle belt is locked, after you install
the infant carrier, pull up rmly on the lap belt
between the Belt Guides. The belt should remain
tight if the vehicle system is locked.
NEVER install this child restraint using a non-locking
vehicle lap shoulder belt. A locking clip MUST BE
used with a vehicle belt that DOES NOT LOCK. Call
the Regal Lager Customer Care Department at
1.800.593.5522 to obtain a locking clip.
5. Push Infant Carrier rmly into vehicle seat
pressing down near the crotch strap between
the child's legs (a), while removing slack
from lap belt. Repeat for shoulder belt. (b)
6. Make sure that vehicle belt buckle and hardware
DO NOT INTERFERE with the Infant Carrier.
30
for how
to see
a
b
a