Using Vehicle Lap Belt Only - CYBEX ATON Manual Del Propietário

Installing the Infant Carrier without the Base

Using Vehicle Lap Belt Only

1. Position Infant Carrier on a forward facing vehicle
seat so child is facing the rear of vehicle.
2. Route vehicle lap belt under both
Belt Guides. Buckle the belt.
3. Push Infant Carrier rmly into vehicle seat, pressing
down near the crotch strap between the child's
legs, while removing slack from the lap belt.
4. Tuck the loose end of the lap belt out of the way.
5. Check the recline angle. Adjust the seat angle until
the RED Level Line on the Infant Carrier is level with
the ground. A tightly rolled towel or pool noodle
may be placed under the Infant Carrier near the
vehicle seat back to adjust the angle. See page 37.
6. Grab the Infant Carrier at the Belt Guides and pull
from side to side and front to back to make sure it
is installed correctly. The Infant Carrier should not
move more than 1 inch (2,5 cm) in any direction.
If the Infant Carrier moves too much, tighten the
vehicle belts more and recheck. You may try a
different vehicle seat or installation method, or
both.
The carry handle MUST be in the CARRY POSITION
when using this child restraint in a vehicle.
NEVER LEAVE an empty child restraint unsecured
in your vehicle.
34
Line MUST be level
with ground when
installed without
Base