Troubleshooting - Logan F300-1 Manual De Instrucciones

Instruction Manual
Trouble Shooting
Problem
V-nail is not driven in all the way.
Joint opens up when driving V-nail in.
Magnetic V-nail holder sticks in the shaft
after insertion of V-nail.
Frame does not assemble correctly.
Gaps in joints.
Clamped moulding does not fit in between posts. Lift Beam off of support rods, and place vise with moulding in
Logan Graphic Products, Inc. ("Logan") warrants the Studio Joiner - Model F300-1, to be free from defects in parts
and workmanship for a period of one year from the date of original purchase. Logan warrants that it will either repair
or replace, at it's sole discretion, any necessary replacement parts found to be defective. Should the product need to
be returned to Logan for repair or replacement parts, authorization for any return must come from Logan in writing.
Costs of returning the product to Logan, including insurances, shall be borne by the purchaser. Logan shall not be
liable for any damages or losses, incidental or consequential, direct or indirect, arising from the use of this product.
This warranty extends only to the original purchaser and is not assignable or transferable. This warranty is in lieu of
Logan Graphic Products Inc., 1100 Brown Street, Wauconda, IL 60084 Toll Free 1 800 331 6232 www.logangraphic.com
Studio Joiner
Solution
Re-adjust depth setting. Refer to instructions.
Use correct size V-nail.
Use the spacer provided and position under where the V-nail is to be
driven in.
Make sure the moulding is securely clamped in vise, and is square
against the fence back.
Remove Beam to gain better access to magnetic V-nail holder and
clean using solvent to remove glue residue.
Use less glue and have damp cloth on hand to clean up any squeeze
out that occurs.
Join sides of frame first, then join halves to finish. Always put longer
length in vise on right hand side and shorter length on left hand side.
Sand Miters smooth.
Make sure the two pairs are equal length.
Reduce the amount of glue in joint.
Check square cutting action of saw.
Use longer V-nails if possible.
between support rods and then re-set beam height, to continue to
press V-nail's in.
Warranty
all other warranties, expressed or implied.
Model F300-1
8