Installing The Interface; Display Customization - Metra 99-7510 Instrucciones De Uso E Instalación

Installing the interface

Attention!: Failure to insert the HVAC cables into the correct location will cause damage
to the interface and make the display and HVAC controls not function properly.
1. Attach the (2) climate control extension harnesses
to the temperature control cable, and the fan
control cable, on the factory climate control.
2. Plug the temperature control cable from the
factory climate control into the port on the
interface labeled "TEMP". (Figure A)
3. Plug the fan control cable from the factory climate
control into the port on the interface labeled
"FAN". (Figure B)
4. Plug the display harness removed in step 1 of kit
preparation into the port on the interface labeled
"DISP". (Figure B)
5. Plug the hazard switch extension cable to the factory
hazard switch, and then into the port on the interface
labeled "HAZARD". (Figure B)
6. Test all functions of the installation for proper
operation, before reassembling the dash.
Note: If the vehicle is equipped with automatic climate
controls, start the vehicle and hold the "AUTO" button
for 10 seconds to program the climate controls.
7. Reassemble the dash in reverse order of disassembly
99-7510
(Figure A)
(Figure B)
7
®

Display Customization

1. Press and hold the A/C Mode
button to scroll through the
various kit options (AMB
TEMP ON or OFF, AMB TEMP
C or F, SET TIME 12/24H,
and SET TEXT).
2. When you see the option you
want just let the button go and
the action on the screen will
be performed. (ie: To turn the
ambient temperature on you
would scroll through until the
display says "AMB TEMP ON"
and let the button go.)
3. To set the time hold down
the A/C Mode button until
the display says "SET TIME
12/24H" then let the button go .
4. To switch between 12H and
24H press the front defrost
button to the left of the A/C
Mode button.
Continued on the next page
TILT
FM1 877
AC
1
2
0
3
A/C
4
MODE
TILT
FM1 877
AC
1
2
0
3
A/C
OPEN
OPEN