Service Parts
15
16
13
9
8
14
7
12
QWIK JON
®
ULTIMA
Item
Description
1
Qwik Jon
Ultima sewage removal system
®
2
Replacement pump with discharge pipe
3
Tank cover with discharge fittings
4
Tank
5
Seal
Float switch assembly/ piggyback foat style
6
Float switch hardware assembly
7
Toilet bowl
Toilet tank with cover 1.6 GPF (6.1 LPF) (left handed)
Toilet tank with cover 1.6 GPF (6.1 LPF) (right handed)
8
Toilet tank with cover 1.28 GPF (4.8 LPF) (left handed)
Toilet tank with cover 1.28 GPF (4.8 LPF) (right handed)
9
Toilet tank cover
10
Rubber coupling with hose clamps
11
Extension kit for behind the wall installation
12
Tank-to-toilet hardware
Flush valve replacement kit - 1.6 GPF (6.1 LPF)
13
Flush valve replacement kit - 1.28 GPF (4.8 LPF)
Fill valve assembly with tube - 1.6 GPF (6.1 LPF)
14
Fill valve assembly with tube - 1.28 GPF (4.8 LPF)
15
Flush valve assembly
16
Flapper with clip and chain
© Copyright 2019 Zoeller
1
3
6
5
2
6
4
202-A & B
202-C
10
11
SK2605
202-A & B
202-C
202-D
10/06 thru
6/16 thru
6/18 thru
5/16
Current
Current
Part No.
Part No.
Part No.
202-1000
202-1000
202-1000
017374
017374
155546
017373
017373
017373
018500
018500
018500
017350
017350
017350
018501
018501
N/A
N/A
N/A
155581
202-2000
202-2000
202-2000
202-3000
N/A
N/A
202-3001
N/A
N/A
N/A
202-3002
202-3002
N/A
202-3003
202-3003
150012
154032
154032
151563
151563
151563
10-3050
10-3050
10-3050
017360
154048
154048
150658
N/A
N/A
N/A
152587
152587
150823
N/A
N/A
N/A
152588
152588
150824
154029
154029
150825
N/A
N/A
®
Co. All rights reserved.
4
Condition
Low voltage, blown fuse, open circuit
Impeller bound
PUMP WILL NOT START OR RUN.
Motor or wiring shorted
Debris on float switch
Float "ON" point is adjusted too low
PUMP STARTS TOO SOON.
WATER LEVEL EXCESSIVE BEFORE PUMP
Float "ON" point adjusted to high
TURNS ON.
Pump not plugged into piggyback float
switch receptacle
Debris under float
Faulty float switch
Float "OFF" point adjusted too low
PUMP WILL NOT SHUT OFF OR RUNS TOO LONG
Pump is air locked
BEFORE WATER IS PUMPED.
Water level too low
Waste material has accumulated
blocking flow of material
Debris around intake
Blockage in discharge pipe
Low or incorrect voltage
Damaged Impeller
PUMP OPERATES BUT DELIVERS LITTLE OR
NO WATER.
Incorrect float adjustment
Pump is air locked
Vertical lift too high
Before servicing a pump, always shut off the
main power breaker and then unplug the pump - making
sure you are not standing in water and are wearing
insulated protective sole shoes. Under flooded conditions,
contact your local electric company or a qualified licensed
electrician for disconnecting electrical service prior to pump
removal.
Submersible pumps contain oil which become
pressured and hot under operating conditions. Allow 2-1/2 hours
after disconnecting before attempting service.
If the above checklist does not solve the problem, consult Zoeller
Product Support Department 1 (800) 928-7867 or 1(502) 778-2731- Do
not attempt to service or otherwise disassemble pump.
© Copyright 2019 Zoeller
Possible Cause
Remedy
Have a qualified electrician check fuse and
circuit.
Contact a Zoeller Service Center.
Remove debris
Raise the float stops, make sure the float is
between the two stops.
Lower the upper float stop.
Ensure pump is not plugged directly into
the outlet. Plug pump into piggyback
float switch receptacle.
Remove debris from around float.
Contact a Zoeller Service Center.
Raise the lower float stop.
Make sure vent hole in discharge pipe is
clear.
Raise the lower float stop.
Hold flush handle down on toilet for 15
seconds. If unit will not clear, unplug
and wait 30 minutes. Plug unit back in
and repeat. If unit still will not turn off,
it will need to be opened and the debris
relocated.
Clean area around intake.
Remove pipe and flush out debris.
Have a qualified electrician check house
wiring.
Contact a Zoeller Service Center.
Contact Product Support Department.
Make sure vent hole in discharge pipe
is clear.
Change discharge piping or contact
Product Support Department.
Do not dispose of feminine sanitary products,
CAUTION
disposable diapers, dish rags, etc. in the QWIK JON
may jam the pump or other plumbing lines and cause malfunction.
CARE OF FINISH: Soap and water is all that is recommended for
cleaning the outside of the tank. Other cleaning products may
cause discoloration and scratching.
Co. All rights reserved.
®
5
®
ULTIMA . They