Craftmade Ellington ANT54AV5WCR Guia De Instalacion página 7

6. Wiring. (cont.)
CAUTION: Be sure outlet box is properly grounded
and that a ground (GREEN or Bare) wire is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions,
please use a qualified electrician.
Note: Excess lead wire length from the fan can be
cut to the desired length and then stripped.
When downrod is secured in place on the
hanging bracket, electrical wiring can be
made as follows:
Connect BLACK wire from fan to BLACK wire
from ceiling with wire connector provided.
Connect WHITE wire from fan to WHITE wire
from ceiling with wire connector provided.
Connect all GROUND (GREEN) wires together
from fan to BARE/GREEN wire from ceiling with
wire connector provided.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
IN ORDER TO WIRE WALL CONTROL, remove
existing wall switch.
After codes have been properly set according to
"Wiring" instructions on previous page, wire the
WALL CONTROL with wire connectors provided
as shown in diagram at right.
* Wrap each wire connector separately with
electrical tape as an extra safety measure. Gently
push wires and taped wire connectors into outlet
box.
Attach wall control to outlet box and secure with
screws from original wall switch. Attach front
plate to wall control using 2 screws provided in
the wall control.
white supply wire
black supply wire
from ceiling
black
white
white
black
from fan
outlet box
page 6
wall
control
green/
green/ green/
bare
bare bare
ground
ground ground
green
black (OUT to fan)
black
black
(TO POWER supply)
black
(AC IN from
breaker box)
ground
(green or bare)
ground
(green
or bare)
*
plate
code
switches