Canopy Assembly; Scroll Arm Assembly - Craftmade Ellington ANT54AV5WCR Guia De Instalacion

7. Canopy Assembly.

Locate 2 screws on underside of hanging bracket
and remove screw closest to the open end of the
hanging bracket. Partially loosen the other screw.
Lift canopy to hanging bracket. Place rounded
part of slotted hole in canopy over loosened
screw in hanging bracket and push up. Twist
canopy to lock. Re-insert screw that was removed
and then tighten both screws securely.

8. Scroll Arm Assembly.

Locate 3 pairs of scroll arm screws in top of
motor housing and remove.
Align holes in the small plate at the bottom of
one of the scroll arms with a pair of the scroll
arm screw holes in the top of the motor
housing. Re-insert 2 scroll arm screws that
were previously removed and then slip tab at
top of scroll arm into one of the slots on the
scroll arm support. Repeat with remaining
scroll arms.
Once all 3 scroll arms are set, tighten set
screw on scroll arm support and then tighten
all scroll arm screws securely. Lower
decorative downrod collar to scroll arm
support, aligning notches in decorative
downrod collar with posts on scroll arm
support. Press down gently on decorative
downrod collar to secure.
decorative
downrod
collar
scroll arm
support
set screw
motor housing
page 7
hanging bracket
canopy
canopy
scroll
arm
scroll arm
screws
small
plate