Extension Cords; Unpacking - Craftsman Trak-Cut 133.33166 Manual Del Operador

ADDITIONAL SAFETY RULES FOR CIRCULAR SAWS
• Blade depth and bevel adjusting locking levers must be tight and secure
before making a cut. If the blade adjustment shifts while cutting, it may
cause binding and kickback.
• Use extra caution when making a "Plunge Cut" into existing walls or
other blind areas. The protruding blade may cut objects that can cause
kickback.
• Do not use the circular saw near fumes or combustible liquids.
• Secure small pieces of wood firmly before working. Never hold them
in your hand.
• Never slow the blade down with your hands or by applying pressure
to the side of the blade.
• Never apply force! Advance the circular saw gently and steadily.
ExTENSION CORDS
• Replace damaged cords immediately. Use of damaged cords can shock,
burn or electrocute.
• If an extension cord is necessary, a cord with adequate size conductors
should be used to prevent excessive voltage drop, loss of power or
overheating. The table shows the correct size to use, depending on cord
length and nameplate amperage rating of tool. If in doubt, use the next
heavier gauge. Always use U.L. and CSA listed extension cords.
RECOMMENDED SIZES OF ExTENSION CORDS
Total length of cord in feet. Cord size in
Tool's
Ampere Volts
25 ft
rating
(7.6 m)
3 – 6 120V~ 18
6 – 8 120V~ 18
8 – 10 120V~ 18
10 – 12 120V~ 16
12 – 16 120V~ 14
A.W.G. (minimum)
50 ft 100 ft 150 ft
(15 m) (30 m) (46 m)
16 16 14
16 14 12
16 14 12
16 14 12
12 - -
8

UNPACkING

Due to modern mass production techniques, it is unlikely that your
CRAFTSMAN Power Tool is faulty or that a part is missing.
If you find anything wrong when the tool is first unpacked from the box,
return the tool to the retailer from which it was purchased for a replacement.
DO NOT operate a faulty tool. Doing so could result in serious personal
injury.
ACCESSORIES
The CRAFTSMAN Trak-Cut Circular Saw is supplied with the following
™
accessories as standard:
• 1 x 3-1/2 in. (89mm) TCT saw blade 24 teeth
• 1 x 3-1/2 in. (89mm) HSS saw blade 80 teeth
• 1 x 3-1/2 in. (89mm) Diamond blade
• Miter base
• Work piece clamp
• Parallel guide
• Dust extractor adaptor
• 3/16 in. (5mm) Allen key
• 1/8 in. (3mm) Allen key
9