Troubleshooting - Craftsman Trak-Cut 133.33166 Manual Del Operador

OPERATION
WARNING. Wear safety goggles, a dust mask and ear defenders.
WARNING. Do not use the scraper in wet or damp conditions.
CAUTION. Where possible, clamp smaller work pieces to the bench.
LUBRICATION
All of the bearings in this tool are lubricated with a sufficient amount of high-
grade lubricant for the life of the tool under normal operating conditions.
Therefore, no further lubrication is required.
18

TROUBLESHOOTING

HEADING
Problem Probable Cause
Tool start switch Motor or motor
will not activate brush failure.
the tool.
Lower blade Wood chips or
guard will not debris blocking
return to locked guard.
position.
Lower guard return
spring broken or
dislodged.
Guard lock broken.
Guard lock spring
broken.
Blade bolt is Blade washer is not
tight but the aligned properly
blade still spins with arbor shaft
freely
Corrective Action
After verifying power to
the tool and verifying that
the start switch activates
properly, try the following:
Tap the plastic body of the
tool with a plastic mallet
or the plastic handle of a
screwdriver and try again.
If the tool still does not
operate, take to a qualified
service dealer for repair.
Unplug tool! Remove any
debris that may be blocking
the guard. Blowout with an
air hose if available (wear
eye protection before using
air hose.)
DO NOT USE TOOL!
Take to a qualified service
dealer for repair.
DO NOT USE TOOL!
Take to a qualified service
dealer for repair.
DO NOT USE TOOL!
Take to a qualified service
dealer for repair.
Loosen blade bolt. Spin
blade washer slightly until
it aligns with arbor shaft
features and will no longer
spin. Retighten blade bolt.
19