Switch For Stationary Operation (Option); Driving; Adjusting The Handlebar Position; Starting The Engine - Rapid Technic MONDO 1550 Manual De Instrucciones

4.12

Switch for stationary operation (option)

The switch for stationary operation enables work with attachments (e.g. combi high-pressure
sprayer, vacuum hose) which can only be operated when the basic machine is stationary (see
chap. 5.11).
During stationary operation, the PTO shaft drive can be driven without actuating the dead
man handle. If the dead man handle is actuated during stationary operation, the PTO shaft
drive deactivates.
5

Driving

It is assumed that you have read and understood the chapters "First things first" and "Safe
operation".
5.1

Adjusting the handlebar position

For ergonomic working with the machine, the handlebar height must be adjusted before
commencing work.
Tilting the handlebar may be helpful when working along hedges or buildings.
5.2

Starting the engine

Prerequisites • Bring the travel drive rotary grip into 0 position.
• Open the fuel valve.
• Actuate the choke (only for cold starts).
• Turn accelerator lever to start position (I).
Starting • Sharply pull the reversing starter evenly until the engine starts running. Then let the cord
procedure slowly wind up again
or
Turn the starter key to position "2" (max. 3 sec.). Release the key as soon as the engine
starts running, it automatically returns to position "1" (in conjunction with electric starter).
• As soon as the engine starts running, slowly push the choke back to its original position
and bring the engine to the desired speed using the accelerator lever.
• Machine is ready for travel.
Adhere to the instructions in the enclosed operating instructions of the engine manufacturer.
5.3

Turning off the engine

Machine No. from 10005183
Note
Note
Note
• Turn accelerator lever to stop in position "L" and
let the engine run for 1 or 2 minutes before
I
stopping.
• Turn accelerator lever to position "O", engine
L
stops.
• Turn the starter key from position "1" to "0" (in
STOP
O
combination with electric starter).
• Close the fuel valve.
EN
137