Avaya 4606 Referencia Rápida página 14

4. After you have attached the stand to the 4612/4624 IP telephone, use the screw provided to
tighten the stand onto the back of the telephone set.
5. Plug the foot-long CAT 5 line cord into the primary Ethernet line interface jack (identified by an
icon on the left that looks like a modular wall jack).
6. Place the other end of the telephone's line cord through the round hole in the middle of the
telephone stand, and snake it out through the rectangular opening in the center of the stand.
7. Plug the line cord into the wall jack.
8. Place the 4612/4624 IP telephone against the wall so that the screwheads on the mounting
plate enter the holes in the stand. Then pull the telephone down so that the screwheads slide
into the cutout channels.
a
b
10