Final Steps - KTM Power Parts 77112945044 Manual Del Usuario

2
16
8
3
2
1
4 5
4
6
7
5
- Connect the starter cable (1) to the starter relay (2) with the AH oval head
screw ISO 7380 M 6X8 (included).
- Mount the starter relay onto the battery compartment on the left..
- Connect the ground wire (3) (included) to the frame with the Ejot spiral
screw (included).
- Connect the relay CM1A-R-12V-H80 (4) (included) to the E-start wiring
harness (5).
- Mount the relay on the battery compartment on the right.
- Attach the start button (6) (included) to the handlebar.
- Remove the start number plate.
- Route the E-start wiring harness (5) under the upper triple clamp between
the fork tube and the steering head pipe toward the front.
Route the cable neatly and without bends and tie it with cable binders. Ensure
that the handlebar can turn all the way.
- Position the counterpiece (7) of the start button in the holder and connect
the start button.
- Remount the control unit (8) and connect the battery (see the Owner's
Manual).
- Route all cables properly.
Route the cable neatly and without bends and tie it with cable binders. Ensure
that the handlebar can turn all the way.
Check that all control elements are functioning properly.
Check the oil level.

Final steps

- Mount the side parts and filter box covers on the right and left.
- Mount the tank.
- Mount the seat.
- Mount the shift lever (14Nm, Loctite243).
- Mount the start number plate.