Signal Output - Inepro PayMatic AD2400 Manual De Instrucciones

Settings
Function P0, Output configuration
By means of this function the relay output can be defined. It is possible to choose between;
- A signal output, which is active throughout the whole session.
- A pulse output which is briefly active/generating a pulse in the beginning of the main time and in
the beginning of the post time.
Setting "00": Signal output
Setting "01": Pulse output

Signal output

Relay 1
Relay 2
Pulse output
Relay 1
Relay 2
End of prior time
Start of main time
Start of prior time
Function P1, External drive facility
Setting "00": Starting the PayMatic happens through a short pulse on the timer button or coin input
(Depending on menu FA)
Setting "01": Starting the PayMatic happens by an external device. This device controls the maintime.
In case the signal is active, then also the timer is active, unless the set time has ended. Interrupting the
active signal will put the PayMatic in post-time (when enabled). The controls is depending on the
setting in menu FA (remote button print input or coin mechanism input).
This setting must be set on 00 for this machine.
Function P2, After start
At the end of a whole session it is possible to allow one extra time of 30 seconds. To obtain this time
the down key has to be pressed. This setting provides a solution for machines, which have to be
connected for a short period of time after the programmed time has expired, e.g. to open the electric
door of a washing machine.
Setting "00": After start is no programmed
Setting "01": After start is programmed
(ECOS module EM-07)
®
PayMatic AD2400(-B) Version 2.0 5-11-2007
- www.inepro.com
End of post time
End of main time
Start of post time
-
17