Enganche Del Tubo Flexible - Vapor 3000 Instrucciones De Uso

ERGONOMIC HANDLE
- The handle is fixed to one end of the hose and may be
either connected to one of the extensions or directly to an
accessory (Fig. 11).
The handle is provided with two switches (Fig. 12).
- Red switch (18): press this switch to enable steam to
be delivered through the accessory.
- Blue switch (19): press this switch to enable detergent
to be delivered.
- By simultaneously pressing the Red (18) and Blue (19)
buttons you will obtain a mixture of steam and detergent.
REFILLING THE WATER RESERVE TANK (G)
To refill the water reserve tank, carry out the following
steps:
-Turn off the main switch (A) and the heater switch (B);
-Unplug the cord from the wall outlet;
-Loosen the cap on the water reserve tank (G) and fill with
water;
-Tighten the cap;
-Plug the appliance into the wall socket;
-Turn ON the main switch (A) and the heater switch (B);
-Operate the appliance as described in section "Preparing
the appliance ready for use" (points a+b).
REFILLING THE DETERGENT TANK (H)
To refill the detergent tank, carry out the following procedure:
- Turn off the main switch (A) and the heater switch (B);
- Unplug the cord from the wall outlet;
- Loosen the cap on the detergent tank (H) and fill with detergent;
- Tighten the cap;
- Plug the appliance into the wall socket;
- Turn ON the main switch (A) and the heater switch (B);
- Press the blue button (19) until the detergent comes out.
Fig. 11
19 18
Fig. 12
26

ENGANCHE DEL TUBO FLEXIBLE

- Abrir completamente la tapa (L) e introducir el empalme
20
rápido (M) del tubo flexible en la toma del aparato,
apretando a fondo (Fig. 8)
- Cerrar la tapa (L) contra el flanco del empalme rápido
(M) del flexible. (Fig. 9)
c) Tras unos 2 minutos desde el inicio del calentamiento
en la caldera apretar la tecla roja (18) en la empuñadura
(Fig. 10) y purgar el aire eventualmente presente en la
caldera y la condensación durante unos 10 segundos.
d) Cuando se enciende el testigo verde (E) el generador
está listo para el funcionamiento.
Durante el funcionamiento, el testigo verde (E)
continuará a encenderse y apagarse para indicar
la vaporización del agua en caldera, es decir el
normal funcionamiento del aparato.
Fig. 8
NOTA
Fig. 9
Fig. 10
75
L
M
M
L
18
19