Assembling The Unit; Mounting The Loop Handle - Stihl HL 100 Manual De Instrucciones

English / USA

Assembling the Unit

1 1
2
2
1
1

Mounting the Loop Handle

Necessary on versions with long
shaft and 135° adjustable cutter bar
(not HL 75 K, HL 100 K).
: Fit the square nuts (1) in the barrier
bar (2) – the holes must line up.
14
2
4
5
7
: Fit the clamp (3) in the loop
handle (4) and place them both
on the drive tube (5).
: Place clamp (6) in position and fit
the barrier bar (2) so that the holes
line up.
: Insert screws (7) and tighten them
down moderately as far as stop
against the barrier bar.
3
6
7
: Align the loop handle (4) and move
it to the most comfortable position.
Distance A must not be more than
21.5 in (55 cm) (about 14 in (35 cm)
is recommended).
: Tighten down the screws (7) firmly.
A
4
HL 100