Stihl HL 100 Manual De Instrucciones página 25

English / USA
: Pull the starter grip slowly with your
right hand until you feel it engage –
and then give it a brisk strong pull.
Do not pull out starter rope to full
length – it might break.
: Do not let the starter grip snap back
– guide it slowly into the housing so
that the starter rope can rewind
properly.
: Crank until the engine begins to
fire. Move the choke knob to e
after no more than five pulls.
: Continue cranking.
As soon as engine runs:
: Blip the throttle trigger – the slide
control moves to the run position #,
and the engine returns to idling
speed.
Make sure carburetor is correctly
adjusted – the cutting blades must
not move when the engine is idling.
Your machine is now ready for
operation.
24
To shut down the engine
: Push the slide control in the
direction of the arrow on the stop
symbol (h) to STOP-O.
At very low temperatures
As soon as engine runs:
: Blip the throttle trigger – the slide
control moves to the run position # ,
and the engine returns to idling
speed.
: Open throttle slightly.
: Warm up engine for short period.
If the engine does not start:
Choke knob
If you did not move the choke to e
quickly enough after the engine began to
fire, the combustion chamber is flooded.
: Set choke knob to e
: Set slide control, interlock lever and
throttle trigger to the starting throttle
position
: Start the engine – pull the starter
rope briskly – 10 to 20 pulls may be
necessary.
If the engine still does not start:
10
: Move the slide control to STOP – 0
: Pull off the spark plug boot (10).
: Unscrew and dry off the spark plug.
: Open the throttle fully.
: Pull the starter rope several times
to clear the combustion chamber.
: Refit the spark plug.
: Connect the spark plug boot and
press it down firmly.
: Move the slide control to START
Set choke knob to e
:
even if engine is cold.
: Now start the engine.
HL 100