Stihl HL 100 Manual De Instrucciones página 33

Ocultar thumbs Ver también para HL 100:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

English / USA
Replacing a broken rewind spring
:
Remove the rope rotor as described
under "Replacing Starter Rope and
Rewind Spring".
The bits of spring might still be
under tension and could fly apart
when you take them out of the
housing. To reduce risk of injury,
wear eye and face protection and
work gloves.
:
Remove spring housing and the
parts of the spring.
:
Lubricate the new spring with a few
drops of non-resinous oil.
32
:
Place the new spring housing on the
recesses (arrows) – bottom plate
must face up.
:
Push the spring housing into the
starter cover.
:
Install the rope rotor as described
under "Tensioning the rewind
spring".
:
If the spring pops out of the housing
during installation: Refit it in the
counterclockwise direction, starting
outside and working inward.
Tensioning the rewind spring
:
Make a loop in the unwound
starter rope and use it to turn
the rope rotor six full revolutions in
the direction of the arrow.
:
Hold the rotor steady – pull out and
straighten the twisted rope.
:
Release the rope rotor.
:
Let go of rope slowly so that it winds
onto the rotor. The starter grip must
locate firmly in the rope guide
bushing. If the grip droops to one
side: Increase spring tension by
adding one more turn.
HL 100

Publicidad

Capítulos

Tabla de contenido
loading

Tabla de contenido