Gima m27322 Manual De Instrucciones página 11

11
SENSOR PAD PLACEMENT
(right foot & right hand or usually use side)
RED
BLACK
Sensor pads G should be placed on one hand and one fool, the side use usually, as shown in the
accompanying diagrams.
On the back of the hand, place a sensor pad on the third knuckle of the middle finger. Place a second
pad on the arm just behind the wrist at the crease observed when the hand is bent back. The edge of the
sensor pad should just touch the crease.
The pad on the foot should be applied just behind the place where the big toe and the first toe join. The
position for the sensor pad at the ankle is found by placing your thumb and forefinger on the two
protruding bones on either side of the ankle and the bringing the fingers forward to the midway point
between the two bones. Place the sensor pad G at the bend of the ankle, in line with the shinbone.
Refer to diagrams for proper placement, and be sure to be consistent each time you test.