Changing The Grinding Belt (Figures 1 + 2) - FEIN Power Tools Slugger GX75USA Manual Del Usuario

GX75.book Seite 13 Donnerstag, 22. März 2012 7:16 07

8. Changing the grinding belt (Figures 1 + 2).

Before any work on the machine itself, pull the power plug from the socket outlet.
WARNING
Loosen star-knob bolt and open protec-
tive cover, top.
Loosen screw and fold the side cover
down.
Loosen star-knob bolt and remove the
dust collector
Push belt tension lever down
to release the clamping device.
Remove the old grinding belt.
Before attaching the new grinding belt,
observe the information concerning the
running direction on the inner side of the
grinding belt! It must correspond with the
running direction of the drive wheel.
Place the grinding belt both around the
drive wheel and around the contact
wheel.
Push the belt tension lever up
again to tension the grinding
belt.
Shut the side cover and tighten screw
again.
Close protective cover, top and tighten
star-knob bolt.
Remount the dust collector and check the
gap size at the grinding rest.
Switch the machine on and adjust the belt
run.
en
13