Electrical Connection - FEIN Power Tools Slugger GX75USA Manual Del Usuario

GX75.book Seite 17 Donnerstag, 22. März 2012 7:16 07
en
17

13. Electrical connection.

Hazardous Voltage
WARNING
Contact may cause electric shock or burn.
When wiring this machine make sure it is properly grounded in accordance with National Elec-
tric code and local codes and ordinances. This work should be done by a qualified electrician.
This machine should be grounded while in use to protect the operator from electrical shock.
The tool is equipped with an approved three-conductor cord three-prong grounding type plug
to fit the proper grounding type receptacle. The green (or green and yellow) conductor in the
cord is the grounding wire. Never connect the green (or green and yellow) wire to a liive ter-
minal. If your unit is a 220/440 V 3-phase system, the connection to the power source should
be done by a four wire cable as shown in figure. When making the connections, check the
motor for proper rotation. To change the motor rotation, switch two of the live leads. The
green wire is always the ground wire and is never to be connected to a live terminal. This work
should be done by a qualified electrician.