Publicidad
Idiomas disponibles
Idiomas disponibles
2.
Place grass bagger into the slots on the rear discharge support
bracket. See Figure 12 inset.
3.
Pivot the grass bagger down so that it rests over the rear
opening of the mower. See Figure 13. Let go of discharge door
so that it rests against the grass bagger.
4.
To remove grass bagger, hold rear discharge door open on the
mower. Lift grass bagger up and off of the slots in the support
bracket. Release rear discharge door to allow it to close the rear
opening of mower.
Figure 12
Figure 13
ASSEMBLY
High Lift Blade Installation
Shut the engine OFF and remove ignition key (if so equipped)
before removing the cutting blade(s) for sharpening or
replacement. Protect your hands by using heavy gloves when
grasping the blades.
Periodically inspect the blade and/or spindle for cracks or
damage, especially after you've struck a foreign object. Do not
operate the machine until damaged components are replaced.
IMPORTANT:
This attachment is best suited for use with the high lift
blades supplied with this attachment. To change the blades on your
28" mower proceed as follows:
1.
Allow the engine to run until it is out of fuel. Do not attempt to
pour fuel from the engine. Disconnect spark plug wire. Refer to
Engine Operator's Manual.
2.
Turn mower on its side making sure that the air filter and the
carburetor are on the side facing up.
3.
Place a block of wood between the center deck housing baffle
and each cutting blade to prevent the blades from turning
when loosening the blade's hex flange nut. See Figure 14.
11
WARNING
WARNING
Figure 14
Publicidad
