Kenwood DMX100BT Manual De Instrucciones página 19

Installation
Ñ Removing the trim plate
1) Use the extraction key (accessory 3) to lever out the
four tabs (two on the upper part, two on the lower
part).
2) Pull the trim plate forward.
Ñ Removing the unit
1) Remove the trim plate by referring to step 1 in
"Removing the trim plate".
2) Insert the two extraction key (accessory 2) deeply
into the slots on each side, as shown. (The protrusion
at the tip of the extraction key must face toward the
unit.)
3
3) Pull out the unit halfway.
✎
NOTE
• Be careful to avoid injury from the catch pins on the
extraction key.
4) Pull the unit all the way out with your hands, being
careful not to drop it.
2
English |
19