Safety Advice In Case Of Replacements; Replace The Driving Wheel Pinion - Checchi & Magli FOX DRIVE PLUS Serie Manual De Uso Y Mantenimiento

Safety advice in case of replacements

When replacing worn or damaged parts, original
spares must always be used.
Special maintenance operations (non included in
this handbook) require a specialised workshop on

Replace the driving wheel pinion

E
H
C
D
UN41-0509MM
For this operation, proceed as outlined below.
1) Move the lever (E) to lift the wheel in order to slack-
en off the chain.
2) Loosen the knobs (A).
3) Remove the casing (B).
4) Loosen the knobs (C).
5) Remove the casing (D).
6) Move the tensioner (F) and remove the chain (G).
CAUTION
The tensioner could move unexpectedly, causing in-
jury to the hands.
Proceed with the utmost caution.
English language
INFORMATION CONCERNING REPLACEMENTS
the premises which meets the requirements speci-
fied by the relative laws in force (appropriate equip-
ment suitably trained staff etc.); if you do not have a
compliant workshop, contact an authorised one.
A
B
M
7)
8)
9)
10) Fit the new chain on the pinions and on the chain
11) Fit the casing (D).
12) Tighten the knobs (C).
13) Fit the casing (B).
14) Tighten the knobs (A).
Repeat the same procedure to replace the pinion on the
other driving wheel.
38
F
L
Unscrew the screw (L) and remove the pinion (M).
From the range of pinions (H), select the most suita-
ble pinion to obtain the required plant spacing (see
page 22)..
Fit the new pinion and tighten the screw (L).
tensioners.
8
G
Use and maintenance