Kohler K-T10278 Guia De Instalacion página 5

Ocultar thumbs Ver también para K-T10278:
Tabla de contenido

Publicidad

Idiomas disponibles

Idiomas disponibles

Spout Supply Tube
Supply Tube Shoulder
Threaded Sleeve
1" (2.5cm)
2-3/8" (6cm) Copper
Tube (Finished
Deck Or Bath Rim
Installation Only)
Rubber Washer
Fiber Washer
Mounting Nut
Hot Supply
2. Installation on Finished Deck or Rim
NOTE: For installation on a rough (unfinished) deck, proceed to
Installation on Rough (Unfinished) Deck.
Use 1/2" nominal, 5/8" O.D. copper tubing. Cut two pieces of
tubing to a length of 2–7/8" (7.3cm). Cut one piece of tubing to a
length of 2–3/8" (6cm) for the spout supply.
IMPORTANT! Leave the protective sleeve on the spout supply tube
until the spout is installed to protect the O-ring sealing surface.
Install Spout Supply Tube
Slide a brass washer from the bottom of the spout supply tube over
the threads until the washer reaches the supply tube shoulder.
Insert the spout supply tube through the mounting hole from the
top of the deck/rim. Ensure that the flat portion of the washer faces
forward. The supply tube will be suspended by the washer.
From the bottom of the deck, slide the plate, with the tabs toward
the deck, and washer onto the spout supply tube. Secure with the
mounting nut.
Secure the plate to the deck with two wood screws.
Kohler Co.
Collar
Washer
Nut
Solder
Solder
5
1-13/16"
(4.6cm) From
Finished
Surface to Top
of Valve Stem
Plate
Brass Washer
Wood Screws
Valve Body
Solder
Cold
1/2" (1.3cm)
Supply
Tee
2-7/8" (7.3cm)
Copper Tubes
1017937-2-A

Publicidad

Tabla de contenido
loading

Tabla de contenido