Luminette Glasses 3 Modo De Empleo página 15

hologram.
Ensure that the battery is charged so that your Luminette® will work for the entire
session chosen. Press the Start-Stop button briefly to turn your Luminette® on
(see figure 1).
To change the intensity of the light, just press the Start-Stop button briefly. The
intensity will change in a cycle: level 1, then level 2, level 3, and back to level 1, etc.
Luminette remains on for a set period, blink three times when the period is over
and automatically shut down. To turn your Luminette® off in the middle of a
session, hold down the On-Off button (for 2 seconds).
G. How to wear my Luminette®
For the best results, you need to wear your Luminette® correctly.
To properly position your Luminette®:
•
Set the nosepiece into one of the three slots (see Figure 1). A "click" sound
means that your nosepiece is correctly inserted. To take it out, pull firmly on it.
•
Place the padded part of the nosepiece where your nose and forehead
meet. The lower edge of the holographic visor should be located just above
your line of sight (see figure 2) when you look into a mirror. Make sure the
blue light strip sits nicely across your eyes.
Please note that if you wear glasses, the nose bracket of the Luminette® should
be behind your glasses (see figure 3).
Once the session has begun, keep your eyes open. Carry on with whatever you are
doing. Do not look directly into the LEDs.
Find the perfect fitment : Luminette is one-size-fits-all; however, if it needs
tweaking for a tighter or looser fit, bend gently the temples in or out. For an even
more secure fit, insert the supplied white plastic "ear-hooks" at the end of the
temples.
H. How to look after my Luminette®
This device is meant exclusively for personal use. Between each use, store the
device in its protective case in a dry place.
To clean your Luminette®, use a soft cloth moistened with a little clean water.
Be careful to protect the fragile holographic zone; avoid touching it with your
EN
15