Opening The Packaging; Assembling The Sa*****2** Frame - Carel ultimateSAM Manual Del Usuario

ENG

1.3 Opening the packaging

•
Make sure the humidifi er is intact upon delivery and immediately notify
the transporter, in writing, of any damage that may be due to careless or
improper transport.
•
Open the shipping container and check contents for damage. If the
humidifi er is shipped unassembled, be sure to locate all of the components.
•
Move the humidifi er to the site of installation before removing internal
packaging. For some installations, assembly may need to take place inside
the AHU.
•
Remove the internal packing, and remove the humidifi er and all of the
accessories.

1.4 Assembling the SA*****2** frame

An unassembled frame is shipped with any SA*****2** ultimateSAM
distributor.
The frame consists of the following:

N. 2 Bottom pedestals (a) If a "P" drain is to be mounted inside the duct
beneath the bottom header, the optional mounting stand will be
needed;

N. 2 Side channels (c);

N. 4 Corner brackets (d) used on bottom feed system;

N. 1 Top channel (e) used on bottom feed system;

N. 2 Top brackets (a) used on top feed system;

Fasteners (M6x10 bolts with locking and fl at washers).
Assemble (but do not tighten) the following parts described in steps A-D,
using the fasteners provided:
A. Fasten the bottom pedestals (a) to the bottom header (b). The choice of
pedestal mounting position depends on the location of the
condensate drain for the bottom header.
a. If an elbow will be attached to the drain, use the mounting holes
for "standard position. " (Fig.1.b) This is the height at which factory-
assembled distributors are built (as pictured on the front cover).
b. If the drain will pass through a hole in the bottom of the duct,
use the mounting holes that provide minimum clearance
("minimized position").
c. If the drain is to be installed inside the duct or AHU, use
the optional mounting stand (SAKS010000) to provide up to
386mm (15") clearance. (Fig.1.c)
B. Fasten the side channels to the bottom pedestals (a).
C. If assembling a bottom feed system [SAB****2**], insert retaining rings
into the top channel of the frame. Fasten the corner brackets to the side
channels. Fasten the top channel to the corner brackets. (Fig.1.d)
D. If assembling a dual feed system [SAT****2**], fasten the top header (f )
and brackets (a) to the side channels. (Fig.1.e).
•
Tighten the fasteners using 7-8 Nm torque (5-6 ft lb), checking to ensure
that the assembly is square.
"Ultimate SAM" +0300013EE - rel. 1.0 - 28.10.2010
Pedestal in
minimized position
Pedestal in
standard position
Optional pedestal
in minimized position
Optional pedestal
in standard position
e
d
a
8
37.5 mm
(1.48 in)
82.5 mm
(3.25 in)
Fig. 1.b
236.6 mm (9.31 in)
386.5 mm (15.22 in)
Fig. 1.c
c
Fig. 1.d
Fig. 1.e