Inserting And Attaching Uprights - Carel ultimateSAM Manual Del Usuario

1.5 Inserting and attaching uprights

•
For a bottom feed distributor,
A.
Tilt the upright, inserting it into the retaining ring in the top bracket.
(Fig.1.f )
B. Continue sliding the upright upward until the bottom of the upright
can be inserted into the hole in the bottom header.
C.
Using 7-8 Nm torque (5-6 ft lb), secure the fl ange of the upright to the
bottom header using the fasteners provided. Before tightening, check
to ensure the o-ring is in the proper position between the fl ange and
distributor. (Fig.1.g)
D.
Continue until all uprights are installed.
Fig. 1.f
O-ring
Fig. 1.g
•
For a top feed distributor,
A. Check that the upper fl ange with o-ring is properly positioned on the
upright.
B.
Tilt the upright, inserting it into the gasket in the bottom header. (Fig.1.h)
C. Continue sliding the upright downward until the top of the upright
can be inserted into the opening in the top header.
D.
Before tightening, check to ensure the o-ring is in the proper position
between the fl ange and distributor. (Fig.1.i)
E. Using 7-8 Nm torque (5-6 ft lb), secure the top fl ange to the top header
using the fasteners provided.
F.
Continue until all uprights area installed.
9 "Ultimate SAM" +0300013EE - rel. 1.0 - 28.10.2010
ENG
Fig. 1.h
Fig. 1.i