Chapter Iv Air Inflation - SATA AE1021 Manual Del Uso

Chapter IV Air Inflation

- Be extremely careful when inflating tires, and strictly follow the following instructions. Because the tire ripper is not designed and
manufactured to protect the people around from sudden tire burst.
- The tire burst may cause serious injury or even death of the operator. Carefully check that the rim and tire are of the same size. Before
air inflation, check that the tires are free from defects or wear. Check the pressure after each air injection. In any case, do not exceed
the pressure value recommended by the manufacturer, and keep your body and hands away from the tire as far as possible.
- The air inflation indicator used to inflate tires shall be under the standard version, and our tire changer is equipped with an air inflation
indicator. The inflation procedures are as follows:
Risk of explosion!
- Do not exceed 3.5 bar (51 psi) when inflating tires; before inflation, the tire will be dismounted from the crankset and placed in a special
protective cage for inflation. Never exceed the inflation pressure recommended by the manufacturer. Hands and body shall be located
on the rear side of the tire being inflated. Only specially trained and authorized personnel are allowed to carry out inflation operation, and
other people are not allowed to operate or stay near the tire changer.
- In this process, the noise can reach 85 dB. Noise protection is recommended.
AE1021/AE1021-3/AE1021H/AE1021H-3
中文
EN DE
1) Connect the air inflation indicator with the tire air
valve;
2) Finally, check the size coordination between the tire
and the rim;
3) Check whether the tire opening is fully lubricated, and
if necessary, carry out further lubrication.
4) Inflate and check the air pressure of air inflation
indicator;
5) Continue to inflate and check the air pressure while
inflating.
RU KO PT JA ES
59