Winding a Bobbin
Pull the thread guide bar up as
far as it will go. Turn the thread
guide bar until the stoppers
click into position.
q Thread guide bar
w Bobbin winding tension disk
e Bobbin hole
r Notch
t Spring
y Bobbin winder spindle
u Bobbin winder stopper
i Bobbin winding button
z Pass the thread through the guide on the
thread guide bar q from behind.
x Pass the thread under the bobbin winding
tension disk w.
c Thread through the hole e in the bobbin from
the inside to the outside.
Match the notch r with the spring t on the
bobbin winder spindle. Then insert the bobbin
on the bobbin winder spindle y.
v Push the bobbin winder stopper to the left u.
b Hold the free end of the thread in your hand
and press the bobbin winding button i. Press
the bobbin winding button again to stop the
bobbin when it has made several turns, and
cut the thread close to the hole in the bobbin.
n Press the bobbin winding button again. When
the bobbin is fully wound, the machine will
stop automatically.
Return the bobbin winder stopper to its
original position. Cut the thread with a
scissors. Remove the bobbin from the bobbin
winder spindle.
NOTE:
This machine has an exclusive motor for bobbin
winding, which allows you to wind a bobbin while
stitching.
A: Stopper
x
w
c
e
y
v
b
n
16
q
z
r
t
u
i