Important; Downrod Style Fan Mounting - Harbor Breeze BELLEVUE E-BE44ABZ5C Manual Del Usuario

INITIAL INSTALLATION
4. Secure mounting bracket (C) to outlet box using
screws, spring washers, and flat washers
provided with the outlet box. (Fig. 4)
*NOTE: It is very important that you use the
proper hardware when installing the mounting
bracket (C) as this will support the fan.
IMPORTANT: If using the angle mount, make
sure open end of mounting bracket (C) is installed
facing the higher point of the ceiling.
5. Remove motor screws (M) and lock washers (N)
from underside of motor housing (D). Note: Use
opening in fitter plate for easy access to motor
screws (M). [If there are plastic motor blocks
installed with the motor screws (M) and lock
washers (N), discard the plastic motor blocks.]
(Fig. 5)
Follow mounting instructions on pages 8 - 10 for
"Downrod Style Fan Mounting" or proceed to
pages 10 and 11 for "Closemount Style Fan
Mounting", depending on mounting method (A or
B) chosen in Step 2 on previous page.

DOWNROD STYLE FAN MOUNTING

Remove pin (P) and clip (Q) from downrod (A).
1.
(Fig. 1A)
Partially loosen set screws in motor housing yoke
at top of motor housing (D). (Fig. 1B)
*Helpful Hint: Downrod style mounting is best
suited for ceilings 8 ft. (2.44 m) high or higher. For
taller ceilings you may want to use a longer
downrod (sold separately) than the one provided.
Angle style mounting is best suited for angled or
vaulted ceilings. A longer downrod is sometimes
necessary to ensure proper blade clearance.
4
C
2 5
Fitter
Plate
D
2 1A
A
Q
8
M
N
1B
Set
Screw
P
D