Harbor Breeze BELLEVUE E-BE44ABZ5C Manual Del Usuario página 9

DOWNROD STYLE FAN MOUNTING
2.
Insert downrod (A) through canopy (B) and yoke
cover (E). Thread wires from motor housing (D)
through downrod (A). (Fig. 2)
3.
Slip downrod (A) into motor housing yoke, align
holes and re-install pin (P) and clip (Q).
Re-tighten set screws in motor housing yoke
and then tighten nuts. Slide yoke cover (E) down
until it rests on top of motor housing (D). (Fig. 3)
Depending on the length of downrod (A) you use,
4.
you may need to cut the lead wires back to
simplify the wiring. If you decide to cut back the
lead wires, it is suggested that you do so in the
following manner:
Take the lead wires and make sure that you
have pulled them all the way through the top of
the downrod (A). Start at the TOP of the ball on
the downrod (A) and measure 8 in. of lead wire,
and then cut the excess wire off with wire cutters.
(Fig. 4)
Note: If you do not cut back the lead wires,
Steps 4 and 5 are not necessary and you may
proceed to Step 6 instead.
2
A
E
3
E
Q
4
9
B
A
P
D
Ball
A