General Notes On Safety; Use Of The Machine For Purposes For Which It Is Intended; Incorrect Use; Declaration Of Incorporation - SUHNER BSG 15/63 Documentación Técnica

1. N

1.1 General notes on safety

This operation manual is applicable for the hand tool BSG
15/63.
The hand tool may only be handled by personnel
who are qualified.
It is imperative that you observe the safety instruc-
tions provided separately for the drive.
1.2 Use of the machine for purposes for
which it is intended
The hand tool is designed for dry applications on metal
surfaces. This takes grinding belts for grinding, satin fin-
ishing, matting, patterning, polishing, and smoothing.
The hand tool may be operated only with the ad-
ditional handle!

1.3 Incorrect use

All uses other than those described under section
1.2 are regarded as incorrect use and are there-
fore not admissible.

1.4 Declaration of incorporation

The manufacturer Otto Suhner AG of Industriestrasse 10,
CH-5242 Lupfig, hereby declares for the partly completed
machinery (see reverse side for type and serial no.) that
the following fundamental requirements of the Directive
2006/42/EC are applied and fulfilled in accordance with
Annex I: 1.1.2, 1.1.3, 1.1.5, 1.2.1, 1.2.2, 1.3.7, 1.3.8.1, 1.5.1,
1.5.4, and 1.6.1. Technical documentation was generated
for the partly completed machinery in accordance with
Annex VII of the Machinery Directive. Document Agent:
M. Voyame. Authorised sites are provided with this techni-
cal documentation in paper or electronic form on justified
request. This partly completed machinery may be put into
operation only when the machine in which the partly com-
pleted machinery is to be incorporated has been ascer-
tained to fulfil the conditions under the Machinery Direc-
tive. CH-Lupfig, 02/2018.
M. Voyame/Divison manage
2. c

2.1 Assembly instructions

hand tools.
Use only hand tools, shafts, and grinding tools in perfect
condition.
Attach the hand tool to the shaft only when the drive is
22
s
otes oN afety
ommiSSioning
It is imperative that you
read Sections 2 and 3 be-
fore you start operating the
switched off and has come to a stop.
Connect grinding tools only when the drive is switched off
and has come to a stop.
It is imperative that you use the guards intended for the
hand tool.
Observe the specifications applying to your country.
2.1.1 Attaching/detaching the hand tool
Press the locking button and insert the hose coupling into
the hand tool hole. Make sure that the locking button is
engaged.
Follow these instructions in reverse order to detach the
hand tool.
2.1.2 Attaching/detaching the additional handle
Move the additional handle to the position you want and
secure it with the screws.