To Prepare A Cold Engine For Start; To Start The Product; To Prepare A Warm Engine For Start; To Stop The Product - Husqvarna 525LK Manual Del Usuario

WARNING: The cutting attachment will
start to rotate immediately when you
start the engine with the choke.

To prepare a cold engine for start

1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Move the choke control up into choke position.
WARNING: The cutting attachment
starts to rotate immediately when you
start the engine with the choke.

To prepare a warm engine for start

1. Push the air purge bulb again and again until fuel
starts to fill the bulb. It is not necessary to fill the air
purge bulb fully.
2. Pull the starter rope handle until the engine starts.
Push the throttle trigger slowly to increase the speed
gradually.
14
CAUTION: Do not pull the starter rope to
full extension. Do not let go of the starter
rope handle when the starter rope is fully
extended. This can cause damage to the
product.

To start the product

WARNING: Read the warning instructions in
the safety chapter before you start the
product (refer to
1. Use protective gloves.
2. Hold the body of the product on the ground with your
left hand.
CAUTION: Do not use your feet!
3. Hold the starter rope handle.
4. Slowly pull out the starter rope with your right hand
until you feel some resistance (the starter pawl grip).
WARNING: Do not twist the starter rope
around your hand.
5. Pull the cord quickly and with power.
CAUTION: Do not pull the starter rope all
the way out and do not let go off the
starter rope handle when the starter rope
is fully extended. This can cause
damage to the product.
6. Pull the starter rope again and again until the engine
starts.
7. Reset the choke when the engine fires.
8. Operate the throttle gradually when the engine
starts.
9. Make sure the engine runs smoothly.

To stop the product

1. Move the stop switch into the stop position to stop
the engine.
CAUTION: The stop switch automatically
goes back to its initial position. In order
to prevent accidental starting, the spark
plug cap must be removed from the
Safety on page 4 ).
1027 - 001 - 23.04.2019