Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
PUMP OIL (FIG. 7, 8)
Drain tank to release air pressure before removing the dipstick
or oil drain plug.
Hot surfaces. Risk of burn. Outlet tube, pump head, and
surrounding parts are very hot, do not touch (see the Hot Surfaces identified in
Important Safety Instructions). Allow compressor to cool prior to servicing.
Risk of property damage. Use SAE 40, non-detergent air compressor
oil only. Multi-weight automotive engine oils like 10W30 should not be used in air
compressors. They leave carbon deposits on critical components, thus reducing
performance and compressor life.
NOTE: Crankcase oil capacity is approximately 10.6 fluid ounces (313.5 mL).
CHECKING
1.
Set the Auto/Off lever to "Off".
2.
Place unit on a flat level surface.
3.
Remove dipstick (Q) and check oil on dipstick for visual
signs of contaminants (water, dirt, etc).
Make sure air vent (V) in dipstick is free
from debris. If air vent is blocked pressure can build
in crankcase causing damage to air compressor and
possible personal injury.
4. Wipe oil from dipstick.
5.
Replace dipstick and allow oil to collect on dipstick.
6.
Remove dipstick and check oil level on dipstick. The
MAX mark on the dipstick indicates full and MIN mark
indicates oil is needed. If oil level is below the MIN mark,
slowly add oil until it reaches the MAX (full) mark on the
dipstick.
7.
Replace dipstick (Q).
CHANGING
1.
Set the Auto/Off lever to "Off".
2.
Allow the unit to cool.
3.
Remove air compressor plug from outlet.
4.
Remove the dipstick (Q).
5.
Remove the oil drain plug (R) and drain oil into a suitable container. (Tilting the
compressor towards the drain plug will assist in draining.)
6.
Replace oil drain plug (R).
7.
Slowly fill crankcase with SAE 40, non-detergent air compressor oil. Crankcase
capacity is 10.6 fluid ounces (313.5 mL). Oil level should be to the MAX mark on
the dipstick.
NOTE: If the oil is added too quickly, it will overflow and appear to be full.
8.
Replace dipstick.
Before you store the air compressor, make sure you do the following:
1.
Review the Maintenance section on the preceding pages and perform
scheduled maintenance as necessary.
2.
Drain water from air tank. See To Drain Tank under Maintenance section for
instructions.
Water will condense in the air tank. If not drained, water will
corrode and weaken the air tank causing a risk of air tank rupture.
STORAGE
16 - ENG
FIG. 8
V
V
Q
Publicidad
Tabla de contenido
