Replacement Parts; Service And Repairs; Troubleshooting - Porter Cable PCFP02040 Manual De Instrucciones

3. Protect the electrical cord and air hose from damage (such as being stepped on
or run over). Wind air hose loosely around the compressor handle.
4. Store the air compressor in a clean and dry location.

REPLACEMENT PARTS

Use only identical replacement parts. For a parts list or to order parts, visit our
service website at www.portercable.com You can also order parts from your nearest
PORTER-CABLE Factory Service Center or PORTER-CABLE Authorized Warranty
Service Center. Or, you can call our Customer Care Center at 1-888-848-5175.

SERVICE AND REPAIRS

All quality tools will eventually require servicing and/or replacement of parts. For information
about PORTER-CABLE, its factory service centers or authorized warranty service centers,
visit our website at www.portercable.com or call our Customer Care Center at 1-888-848-
5175. All repairs made by our service centers are fully guaranteed against defective material
and workmanship. We cannot guarantee repairs made or attempted by others.
You can also write to us for information at PORTER-CABLE, 4825 Highway 45 North,
Jackson, Tennessee 38305 - Attention: Product Service. Be sure to include all of the
information shown on the nameplate of your tool (model number, type, serial number, etc.).
Since accessories, other than those offered by PORTER-CABLE,
have not been tested with this product, use of such accessories with this tool could be
hazardous. To reduce the risk of injury, only PORTER-CABLE recommended accessories
should be used with this product.
A complete line of accessories is available from your PORTER-CABLE Factory Service
Center or a PORTER-CABLE Authorized Warranty Service Center. Please visit our Web Site
www.portercable.com for a catalog or for the name of your nearest supplier.
Risk of Unsafe Operation. Unit cycles automatically when
power is on. When servicing, you may be exposed to voltage sources,
compressed air, or moving parts. Before servicing unit unplug or disconnect
electrical supply to the air compressor, bleed tank of pressure, and allow the
air compressor to cool.
PROBLEM
Excessive tank
pressure - safety
valve pops off.
SERVICE
ACCESSORIES

TROUBLESHOOTING

CAUSE
Pressure switch does
not shut off motor when
compressor reaches
"cut-out" pressure.
Pressure switch
"cut-out" too high.
17 - ENG
CORRECTION
Move Auto/Off lever to the "Off"
position, if the outfit does not
shut off have checked by a
Trained Service Technician.
Have checked by a Trained
Service Technician.