ASSEMBLE AIR INTAKE FILTER (FIG. 2)
Risk of unsafe operation. Do not operate without air intake filter.
Remove shipping plug (U) from air intake inlet and assemble air intake filter (P). Tighten
until snug.
HOW TO SET UP YOUR UNIT
LOCATION OF THE AIR COMPRESSOR
•
Locate the air compressor in a clean, dry and well ventilated area.
•
The air compressor should be located at least 12" (30.5 cm) away from the wall
or other obstructions that will interfere with the flow of air.
•
The air compressor pump and shroud are designed to allow for proper cooling.
The ventilation openings on the compressor are necessary to maintain proper
operating temperature. Do not place rags or other containers on or near these
openings.
•
Keep the compressor away from the areas that have dirt and/or volatile fumes in
the atmosphere. These impurities may clog the air intake filter and valves, causing
inefficient operation.
•
Place the air compressor on a flat surface resting on the rubber feet.
NOISE CONSIDERATIONS
Consult local officials for information regarding acceptable noise levels in your area.
To reduce excessive noise, use vibration mounts or silencers, relocate the unit or
construct total enclosures or baffle walls. Contact a Trained Service Technician for
assistance.
ELECTRICAL (FIG. 4)
Refer to all safety instructions before using unit. Observe extension cord safety
instructions if necessary. Always move the Auto/Off switch (D) to the "Off" position
before removing the plug from the outlet.
TRANSPORTING
When transporting the compressor in a vehicle, trailer, etc., ensure that the tank is
drained and the unit is secured. Use care when driving to avoid tipping the unit over
in the vehicle. Damage can occur to the compressor or surrounding items if the
compressor is tipped.
MOVING
When moving the compressor, grasp the handle and carry the compressor as close
to the body as possible.
Risk of unsafe operation. Ensure proper footing and use caution when
carrying compressor to avoid a loss of balance.
FIG. 2
P
INSTALLATION
9 - ENG
U