Hach NA5600 sc Na+ Manual De Operaciones página 3

Table of Contents
1 Safety information
2 Startup on page 3
3 User interface and navigation
Section 1 Safety information
Refer to the installation user manual for general safety information, hazard descriptions and
precautionary labels descriptions.
Section 2 Startup
Connect the power cord to an electrical outlet with protective earth ground.
2.1 Set the power switch to on
Refer to the illustrated steps that follow.
2.2 Complete the startup wizard
1. If the startup wizard does not start automatically, push menu then select SETUP SYSTEM >
STARTUP ANALYZER.
2. Follow the instructions on the display.
• If prompted to set the channel sequence (measurement order), use the UP and DOWN arrows
to select a row, then push the LEFT or RIGHT arrow to select the channel. S1 is the first
channel measured followed by S2, S3 and S4.
Note: Do not select channels that contain the symbol "~" (e.g., 4-~SAMPLE4). Channels that contain the
symbol "~" are not measured.
• When prompted to adjust the sample flow rate for a channel, turn the sample flow valve for the
channel counter-clockwise to increase the flow rate or clockwise to decrease the flow rate.
Refer to Figure
When the startup wizard is complete, the analyzer goes to measurement mode. The overflow
vessel fills with sample water. Bubbles (conditioning gas) are seen in the right chamber of the
measurement cell.
3. Become familiar with the keypad functions and the data shown on the measurement screen.
Refer to User interface and navigation
4. Configure the analyzer. Refer to
on page 3
on page 4
1.
on page 4.
Configuration
4 Configuration on page 8
5 Calibration on page 23
6 Operation on page 26
on page 8.
English 3