Axxess AX-ADCH100 Instrucciones De Instalación página 3

Only make the following connections if the vehicle is amplified.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire of the aftermarket
navigation radio.
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
navigation radio.
• Connect the Green/Purple wire to the reverse wire of the aftermarket
navigation radio.
AX-ADCH100
Installing the Interface
From the 22-pin Chrysler harness
• Connect the Yellow wire to the radio's 12-volt battery or memory wire.
• Connect the Black wire to the radio's ground wire.
• Connect the Blue/White wire to the radio's amp turn on wire if populated on
Amplified vehicles
• Connect the two 4-pin connectors with the Purples and Greens
Non-amplified vehicles
• Disconnect the two 4-pin connectors with the Purples and Greens in it.
• From the 22-way Gray connector, connect the 4-pin with the Whites
3
the factory side.
wires in it together.
and Grays to the 4-pin with the Purples and Greens coming from the Black
22-way connector.