Axxess AX-ADCH100 Instrucciones De Instalación página 5

AX-ADCH02 Harness
From the 16-pin harness
• Connect the (2) Red wires to the ignition/accessory wire of the aftermarket radio.
• Connect the Orange/White wire to the illumination wire of the aftermarket
radio. If the aftermarket radio does not have an illumination wire, tape off the
Orange/White wire.
• Connect the Blue/White wire to the amp turn on wire of the aftermarket radio.
• Connect the Brown wire to the mute wire of the aftermarket radio. If the
aftermarket radio does not have a Mute wire, tape up the Brown wire.
• Connect the White wire to the left front positive speaker output of the
aftermarket radio.
• Connect the White/Black wire to the left front negative speaker output of the
aftermarket radio.
• Connect the Gray wire to the right front positive speaker output of the
aftermarket radio.
• Connect the Gray/Black wire to the right front negative speaker output of the
aftermarket radio.
AX-ADCH100
Installing the Interface
Only make the following connections if the vehicle is amplified.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
The following wires are for the aftermarket radios that have navigation built in.
• Connect the Light Green wire to the parking brake wire of the aftermarket
• Connect the Blue/Pink wire to the VSS or speed sense wire of the aftermarket
• Connect the Green/Purple wire to the reverse wire of the aftermarket
5
navigation radio.
navigation radio.
navigation radio.