Axxess AX-ADCH100 Instrucciones De Instalación página 4

• Connect the 4-pin harness with stripped leads to the 4-pin with the Greens and
Purples coming from the Gray 22-pin connector.
• Connect the Green wire to the radio's left rear positive speaker output.
• Connect the Green/Black wire to the radio's left rear negative speaker output.
• Connect the Purple wire to the radio's right rear positive speaker output.
• Connect the Purple/Black wire to the radio's right rear negative speaker output.
12-way harness
This harness is for the ASWC-1 (sold separately). Please refer to the ASWC-1
instructions for programming.
Installing the AX-ADCH01
• With all connections completed to the aftermarket radio, plug the 22-pin harness
into the vehicles wiring harness.
• Reconnect the negative battery terminal.
AX-ADCH100
Installing the Interface
• Cycle the key, by turning the ignition on for 30 seconds. Then off and on again
Testing the AX-ADCH01
• Turn the ignition on if not already, and then turn the radio on to verify that the
For amplified vehicles (only)
• To adjust the overall volume of your audio system, rotate the potentiometer which
4
to test the radio.
radio works. Check balance and fader controls for proper operation.
is located on the 16-pin side of the interface clockwise.