Tabla de contenido
Publicidad
Idiomas disponibles
Idiomas disponibles
STEP 5
Hang the Filter System Head
1
A
Align the System Head
on the pipes so that the inlet and outlet are in the correct locations. The "in" port on the Filter System should
be facing the incoming water supply.
2
Allow the System Head to temporarily hang between the two cut plumbing pipes.
3
Apply plumber's tape or appropriate sealant to the fittings and lines, according to your system configuration.
4
Make all connections and tighten fittings.
NOTE: Keep the Filter System in an upright position.
5
Attach the optional mounting bracket (not included) to the wall using four mounting screws or alternative fasteners (not included).
A grounding kit (not included) must be installed on water pipes if they are used to ground electrical systems, appliances or phones.
STEP 6
Hang the Filter Housing
C
1
Insert the Filter Cartridge
over standpipe in the bottom of the Filter Housing
2
Screw the Filter Housing back onto the System Head and hand-tighten
IMPORTANT: Do not over tighten.
WFHD13001
CAUTION
GROUNDING KIT (NOT INCLUDED)
A.
.
Using the Filter Housing Wrench
D
, tighten 1/4 turn.
6
5
IN
A
WATER
FLOW
HOUSE
3
5
6
D
A
OUT
TO
2
V4.1E
Publicidad
Tabla de contenido
