Proper Installation; Before You Begin - Du Pont WFHD13001 Serie Manual De Instrucciones

Proper Installation

Please read all instructions, specifications, and precautions before installing and using your water filter system.
CAUTION
This filter must be protected from freezing, which can cause cracking of the filter
and water leakage.
Precautions:
For cold water use only.
After prolonged periods of non-use (such as during a vacation), it is recommended that the system be flushed thoroughly. Let water run for
10 minutes before using.
The filter cartridges used with this system have a limited service life. Changes in taste, odor, and/or flow of the water being filtered indicate
that the cartridge should be replaced.
Do not install where system will be exposed to direct sunlight.
Your water filtration system will withstand up to 100 psi water pressure. If your house water supply pressure is higher than 100 psi, install a
pressure reducing valve before the system is installed.

Before You Begin

Locate the main water supply line to your home and check to see what type of plumbing is in place (ex: plastic, copper, galvanized).
n
The main water supply line is typically located in a basement, crawlspace or garage.
Measure the diameter of the existing pipe to determine what size fittings and/or valves (not included) will be required.
n
Choose a location in the main supply line to install the Filter System. Make sure to place the Filter System in an area after the water
n
meter or pressure tank and before the water heater. Also select a location that will be easily accessible when changing filter cartridges.
Consult your local plumbing codes and install accordingly.
n
STEP 1
Turn Off the Main Water Supply Line
CAUTION
The Filter System must be installed after the water meter or pressure tank.
1
Turn off the main water supply line to your home.
2
Purge all water from the plumbing lines by turning on all faucets in your home and draining completely.
WFHD13001 3
1
V4.1E