Connect The Suction Assembly - Kohler K-1000-H2 Guia De Instalacion

Pump
Pump Drainage

8. Connect the Suction Assembly

Orient the Pump
Remove the pump from the shipping box and position it near where it will be installed.
NOTE: The pump and control must be properly oriented for your installation. If the pump is facing the
proper direction and the cooling fins face away from the footbath, as shown in the illustration, proceed to
Install the Suction Assembly.
The pump should be oriented with the control cooling fins situated away from the footbath.
If the cooling fins are not properly oriented, detach the pump from the control by removing the four
nuts.
Turn the pump 180° so it is facing in the opposite direction.
Confirm that the cooling ribs are properly situated and re-attach the four nuts.
Securely tighten the nuts.
Install the Suction Assembly
Locate the heater subassembly. It is located in the kit that was packed with the pump.
Orient the heater subassembly so that it will connect the suction line to the pump. This step will
determine the final position of the pump.
Position the O-ring and attach the heater end of the assembly to the suction line.
Position the O-ring and attach the opposite end of the assembly to the pump.
Kohler Co.
Pump
Place cooling fins to
the outside of pump
Ensure minimum 1/4"
(6mm) pitch per foot
(30.5cm) toward suction
assembly
Heater Subassembly
Suction Line
9
Pump
1032108-2-A