Advice
If there occurs an irregular false indication of an obstacle, it can be due to frost on the
sensors. Clean the sensors.
Should there sound a special warning tone after the introductory tune immediately,
one of the sensors has been disconnected or damaged. The number of the faulty
sensor is indicated by the number of short beeps following the warning tone:
1 beep
2 beeps
3 beeps
4 beeps
Spare sensors can be ordered under the ordering Nos.:
BEA 700 001 01 – central sensors
BEA 700 001 02 – corner sensors
Warning
The capacity of the system to detect obstacles depends on their material and
shape!
The acoustic signalling during backing does not exempt the driver from the lia-
bility for damages caused during parking the vehicle and similar manoeuvres.
Therefore, before backing make sure that there is no small-sized obstacle be-
hind your vehicle (e.g. a stone, a thin pillar, a draught pole of a trailer etc.). Such
an obstacle could be outside the monitored area.
corner sensor No. 1 (PIN 11, 23)
central sensor No. 2 (PIN 9, 21)
central sensor No. 3 (PIN 10, 22)
corner sensor No. 4 (PIN 12, 24)
GB