SATA J Serie Manual Del Uso página 18

Operation
Start/stop （ see Figure B）
1.
Press and hold the switch （1） to start the machine, and release it to stop the machine.
2. Speed regulation
Change the force applied to the switch to regulate the rotating speed. The range of adjustment is between 0 and the maximum rotating
speed. The smaller the force is, the lower the rotating speed is. The drilling starts slowly and stably. After the stable and reliable start,
press the switch fully for higher speed.
Warning
Do not operate at low speed for a long time by pressing the switch. Otherwise the machine will be overheating inside.
Change the rotating speed after stop.
Switch lock （see Figure C）
3.
The switch has the lock protection function which helps to avoid the accidental activation of the hand drill. Lock the machine by adjusting
the reversing yoke （2） to the center position.
Rotation reversing （see Figure C）
4.
Forward: Push the side of reversing yoke （3） marked with "← " to the end （left side） for drilling a hole and driving the screw. Reverse:
Push the side of reversing yoke marked with " → " to the end （right side） for releasing or unscrewing the screw.
Warning
The rotating speed can only be changed after the machine is completely still.
Installation or removal of screwdriver bit （ see Figure D）
5.
Caution: When installing or removing the bit, be sure to confirm that the machine has been turned off and that the battery pack has
been removed.
The machine is designed with a quick-loading chuck system;
When installing the screwdriver bit, pull the sleeve forward and insert the screwdriver bit into the chuck. Loosen the sleeve to fix the
screwdriver bit.
When removing the screwdriver bit, pull the sleeve forward and pull the bit out, and then release the sleeve to reset it.
Warning
Before starting the machine, make sure that the screwdriver bit is fully fixed by the chuck.
6. Work light
Machine is equipped with the work light: when the switch is pressed, the light will come on; when it is released, light will go out.
Battery level display （ Figure E）
7.
When the machine switch is pressed, the battery indicator will come on. The remaining capacity of battery pack may be determined
according to the following table, and when the switch is released, the indicator will go out.
8. Operation
18
51086
中文
EN DE RU KO PT JA ES