SATA AE5603 Manual Del Uso página 44

2.3 Use of Wedge for rear wheels
In the Kingpin measurement, to prevent the vehicle moving,which affects the measured data, block the rear wheel by rubber
wedge, and then take out the pins on turn plate and remove the rubber pad. (for reference only)
2.4 Selection of Clamps
2.4.1 Four Wheel Aligner Special Clamps Introduction
The clamps with four claws is specially designed for four wheel alignment,which can align common type as well as the type
with low chassis. Goodlooking and easy to use. as following picture:
Taper pin
Big nut
AE5603
hand wheel
Side frame
rod
middle frame
screw rod
Hexagon nut
(Pic 1)
wheel hub
(Pic 2)
42
- 03 -
EN EN DE DE RU RU KO KO PT PT
Rim of hub is close to ends of claw
JA JA ES ES