Descargar Imprimir esta página

SATA J Serie Manual Del Uso página 21

Amoladora angular sin escobillas de batería de litio de 18v (100mm/125mm)
Ocultar thumbs Ver también para J Serie:

Publicidad

Idiomas disponibles
  • MX

Idiomas disponibles

  • MEXICANO, página 89
4) Installation of shield:
Step 1: open the shield lock(1);
Step 2: Align the bump (2) on the shield with the notch on the gearbox;
Step 3: Press down the shield until the shield is inserted into the gearbox, and the bump (2)is engaged in the groove on the
gearbox (3);
Step 4: Rotate the shield between the output shaft and the operator. Select an appropriate angle, and then lock the buckle (1).
5) Adjustment of shield(Figure E):
When the shield is delivered, it has been pre-adjusted to a position where it can be tightened. If the shield becomes loose after a
period of use, tighten the screw (1)in the figure with the shield tightened.
6) Removal of shield:
In reverse order of installation: first loosen the buckle, rotate the shield, and align the bump on the shield with the notch on the
gearbox and pull out the shield vertically.
7) Installation and removal of wheel(see Figure F.G.H):
Warning:
When the tool is equipped with a wheel, be sure to use the wheel shield. The wheel may be crushed during use. The shield may
help reduce the risk of personal injury.
8) Installation of wheel:
Step 1: Turn off the switch and pull out the battery pack
Step 2: Install the inner pressure plate without thread on the spindle, with a side with step downwards, and get it caught on the
spindle
Step 3: Install the wheel on the inner pressure plate
Step 4: Drive the threaded outer pressure plate clockwise into the spindle
Step 5: Press and hold the spindle lock button (1 in Figure G)to prevent the spindle from rotating. Tighten the outer pressure
plate clockwise with the locking wrench(Figure H).
Note:
When the thickness of wheel is greater than 3 mm, the side of outer pressure plate with the center boss is in contact with the
wheel; when the thickness of wheel is less than or equal to 3 mm, the side of the outer pressure plate with the center groove is
in contact with the wheel.(See Figure I.J)
9) Removal of wheel:
Warning:
The axis lock can only be used when the spindle stops rotating.
After confirming the shutdown and unplugging the battery pack, repeat the above steps in reverse order.
51090
中文
EN
DE
RU
KO
PT
JA
ES
21

Publicidad

loading

Este manual también es adecuado para:

51090