SATA J Serie Manual Del Uso página 23

5） Cutting operation（see Figure M）:
Note:
According to the material of workpiece, the wheel of different material shall be selected, and the recommended diameter is
adopted. The maximum rotating speed of wheel shall be more than 13000 rpm. The inner hole shall fit the pressure plate tightly.
Keep the working environment and workpiece clean and tidy.
Place one hand on the outer casing, and the other on the side handle, hold and start the tool, wait for the tool to reach the
maximum rotating speed, slowly place the wheel on the workpiece, and exert a slight force to improve the cutting efficiency.
Once the incision is formed, do not change the cutting angle. Otherwise, the wheel will be easily deformed and broken, causing
a risk of injury. When the work is finished, separate the machine from the workpiece and then release the switch.
Warning:
Do not squeeze the wheel or apply an excessive pressure. Avoid the deep cutting, which will increase the load, make the wheel
easy to twist or stick and increase the possibility of rebound or damage to the wheel. The wheel may break and the motor may
overheat.
Always use the accompanied guard, and do not use the guard or be sure to carry the guard;
Never use the cut-off wheel for grinding.
Never initiate a cutting operation in the workpiece. Please carefully insert the wheel into the surface of cutting workpiece after
it reaches the full speed. If the electric tool starts in the workpiece, the wheel may stick, move or rebound.
Do not change the angle of wheel during the cutting operation. Applying a side pressure to the cut-off wheel will cause the
wheel to crack and break, resulting in the serious personal injury.
6） Air filter net（Figure N）:
To prevent the debris from entering the inside of machine, a filter net is set at the air inlet. After the machine is used or stored for a
long time, please pull it down and clean it.
7） Battery level indication:
When the machine switch is pressed, the battery indicator will stay on for 5s. The remaining capacity of battery pack may be
determined according to the following table.
LED display
Question and answer:
1） Why does the machine not operate after the switch is pressed?
Check if the level of battery pack is too low.
Check if the battery pack is installed properly.
51090
中文
EN DE RU KO
Remaining battery
0-25%
25-50%
50-75%
75-100%
PT JA ES
23